PLA Tech with load of up to 10% of metallic particles
Metallic effect without post-processing.
Embalado em vácuo com material dessecante e empacotado em caixa anti-stress
Warning: Last items in stock!
FilaMETAL is a PLA filament with metallic particles suitable for 3D printing FFF.
The metallic load that incorporates makes that the printed pieces with it have a metallic finish without the need for post-processing.
For the manufacture of this filament only 100% virgin PLA NatureWorks origin USA pellets are used. The dyes used have been specially selected for colors to retain their properties after printing.
Since it is a PLA this filament can be used in the total practice of the printers of the market since its characteristics and the parameters with which it is printed are similar.
PLA is a thermoplastic filament of vegetable origin made from a polymer obtained from corn starch with properties similar to those of polyethylene terephthalate (PET), which is used to make containers but is also biodegradable.
It is considered as the easiest material to print and therefore is sometimes recommended for beginners. This is because it has much better adhesion than ABS allowing it to be printed even without "warm bed". Now for optimal results it is recommended to use hot bed at 60º and lacquer.
For optimum finishes it is recommended to use a layer fan when printing with PLA. It depends on the hot-end used, also cooling here is necessary.
Due to its vegetal origin, it is respectful with the environment and gives off a pleasant sweet aroma when it is printed with it.
PLA is a hygroscopic material that tends to absorb moisture. For this reason we recommend that it be stored in an airtight bag with desiccant material and stored in a dry and dark place while it is not in use.
|Material||P.L.A. - Polylactic acid|
|Net weight||250 G|
|Total weight (Spool and box included)||350 G|
|Printing temperature||180ºC -195ºC|